✨ Why You’ll Love This Mod

Tired of that annoying hyper-flash after upgrading to LED turn signals? Our 50W Load Resistors are a quick, easy fix for many vehicles experiencing rapid blinking. While not a guaranteed solution in all cases, they offer a convenient and widely used option to restore normal turn signal function.

🔧 May fix hyper-flashing in many vehicle setups
⚡ Simulates halogen bulb load (7.5 ohm, 50W)
💪 Built for heat resistance + weather protection (IP67)
🚘 Compatible with most LED turn signal upgrades
🔩 Includes mounting hardware for clean installs

🔥 Swap to LEDs with less hassle. These resistors help restore factory blink speed for many builds—but read below for important details on compatibility.

🚨 Important Disclaimer on Hyper Flashing

Hyper-flashing happens when your vehicle's system doesn't detect enough power draw from LED bulbs. While these resistors simulate the proper load and may work for many setups, they are not a guaranteed fix for all vehicles.

Factors that may affect success:

Vehicle year/make/model
CAN bus systems and bulb-out detection
Whether resistors are installed on the correct wires
Whether your vehicle has additional modules/sensors

💡 What Are Load Resistors?

Load resistors trick your car into thinking it’s still running halogen bulbs by drawing extra power. Without them, some cars will blink rapidly or show "bulb out" warnings when LEDs are installed.

🔁 Other Solutions to Try

If load resistors don’t solve the issue, here are other potential fixes:

LED flasher relay replacement (for older vehicles)
Dedicated anti-hyperflash modules (for some newer cars)
Upgraded LED bulbs with built-in resistors
Programming via dealership or scan tool (common in Euro vehicles)

👉 Still stuck? Check out our Hyperflash Help Guide or reach out—our support team can help troubleshoot your specific setup.

📦 What’s Included

2x 50W 7.5 Ohm Load Resistors
Mounting Hardware
Installation Instructions

🔧 Installation Notes

Wire one resistor in parallel for each LED turn signal (front and/or rear). Resistors get hot—mount to metal surfaces only, not plastic or wiring looms. We recommend testing before fully securing them.

📘 Technical Specs

Power Rating: 50 Watts
Resistance: 7.5 Ohms
Operating Temperature: -40°C to 125°C
Waterproof Rating: IP67

Install Components & Wiring